MTS TECHNIK E3 COILOVERS

Coilover Kit MTS Technik for BMW 2500-3.3 / E3, lowering the front axle between 25 - 85 mm, and rear between 30 - 95 mm.

Dedicated for the years of: 10/68 - 04/77, for the engine version: 2500 / 2800 / 2.8 L / 3.0 S / 3.0 L / 3.0 Si / 3.2 Li / 3.3 L.

The front coilovers need welding to the original struts - We can offer this service in house if the original struts are sent to us. Please contact us for a quote. 

FEATURES:

2 year warranty with no mileage limit to confirm high quality.

Suspension components characterized by increased corrosion resistance and made of the highest quality materials.

The use of twin-tube technology guarantees stable shock absorber performance.

Pressurized gas presses the hydraulic fluid, eliminating the "foaming" effect of the oil (an undesirable and typical for oil shock absorbers phenomenon), which means higher efficiency for continuous, intensive work.

Specially selected type of thread and a wide range of suspension adjustment allows optimal setting of the car height.

The camber plates allow the wheel angle adjustment and increase the precision of driving.

Innovative hexaCOIL spring perch, significantly increasing the comfort of suspension height adjustment.

Additional height adjustment at the bottom mounting, allowing the car's height reduction to be changed, without interfering with the spring operation characteristics.

Double zinc plated steel shock absorbers as well as anodized aluminum adjusters and caps to ensure increased corrosion resistance.

Coilover springs made by Eibach, the world leader in the sport springs industry.

SPECS:

- Front and rear axle height adjustable (threaded shock absorber housing).

- If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.

 - During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.

 - Independent height adjustment at the lower brackets on the front dampers.

 - Set includes 2x upper "camber plates" on the front axle.

 - The installation requires the use of OE front struts - they should be cut and welded as described in the attached manual.

 - In some cases additional OE-parts for the installation of the suspension components are required. Those are not included in the set.